Hot-max-torches HM6500 Manuel d'utilisateur télécharger pdf (Page 6)

KDAR Company 5

Set Up

Wheel & Handle Assembly

Note: All fasteners can be tightened as each

procedure is completed. There is no need to

wait until assembly is complete to tighten the

fasteners.

1. Using 2 M8x20 bolts and 2 M8 nuts, attach the

2 rubber feet to the front support.

2. Using 4 M8x20 bolts and 4 M8 nuts, attach the

front support to the lower cross beam by lining

up the 4 holes in the fronts support with the 4

holes in the cross beam. It may be easier to at-

tach the front support by carefully tipping the

generator on its end.

NOTE: Do not tip the generator on its end if

you have already put gas or oil into the unit.

3. Insert the axles into the axle support sleeves on

the lower frame. Make sure the holes in the

axle lines up with the hole in the support.

4. Insert cotter pins through the holes and bend

one leg to secure the pin.

5. Slide wheels over the axles making sure the

long side of the hub is facing in toward the

frame.

6. Slide washers over the axles and against wheel

hub.

7. Insert cotter pins through holes and bend one

leg to secure the pin.

8. Using 2 M8x50 bolts and 2 M8 nuts attach the

handle pivot bracket to the upper cross bar by

lining up the holes in the brackets with the

holes in the cross bar.

9. Attach the handle catch to the middle cross bar

using the M6x60 bolt and M6 nut by lining up

the hole in the catch with the hole in the cross

bar.

10. Using the M8x58 bolt and a M8 nut attach the

handle to the handle pivot bracket by sliding

the bolt through the holes in the bracket and

handle and tightening.

Engine Preparation

Engine Oil

NOTE: Engine oil is a major factor affecting

the performance and service life of this genera-

tor. Non-detergent and 2-stroke engine oils

WILL damage the engine and are not recom-

mended.

1. Use 4 stroke oil, or an equivalent high deter-

gent, premium quality motor oil certified to

meet or exceed U.S. automobile manufactur-

er’s requirements for Service Classification

SG, SF/CC, CD. This designation will be on

the motor oil container.

2. SAE 10W-30 is recommended for general, all-

temperature use. See chart for appropriate

weights for your area.

3. Locate the oil filler cap and remove.

Oil Filler

Cap

4. Fill with 1.16 quarts (1.1

Liters) of motor oil.

5. Confirm proper fill by re-

placing the dip stick and

checking the oil level.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire