Hot-max-torches HM6500 Manuel d'utilisateur télécharger pdf (Page 8)

KDAR Company 7

Operation

Starting the Engine

1. Check the oil and fuel levels.

2. Disconnect all electrical loads from the genera-

tor.

3. Open the fuel shut off valve.

Pre-Start Preparation

NOTE: The following procedures are to be

completed each time the generator is started.

1. Before starting the generator, check to make

sure there are no loose or missing parts.

WARNING

The generator must not be operated if all facto-

ry installed heat shields are not in place. Failure

to comply may result in the fuel tank over heat-

ing which could cause personal injury from fire.

4. Pull out choke (if starting a cold engine).

5. Flip ON/OFF switch to the ON position

6. Pull starter rope with a fast steady pull.

Starter

Rope

Handle

7. As engine warms up return choke back to open

position

CAUTION

Allow the generator to run for 5 minutes each

time it is restarted before applying load. This

will let the engine and generator stabilize.

DANGER

 Provide adequate ventilation for

toxic exhaust gases and cooling air

flow.

 Do not start or run the generator in

and enclosed area, even if windows

or doors are open.

 Engines give off carbon monoxide, a

odorless, colorless, poison gas.

 Breathing carbon monoxide can

cause nausea, fainting or death.

Applying Load

 This generator has been pre-tested and adjusted

at the factory to handle its rated load.

 Apply load only after the generator is running

and has warmed up for 5 minutes.

 Voltage is regulated by the speed of the engine

which is adjusted at the factory for correct out-

put. Readjusting will void the warranty.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hot-max-torches HM6500 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Hot-max-torches HM6500