Hot-max-torches HM6500 Manuel d'utilisateur télécharger pdf (Page 9)

KDAR Company 8

Operation

CAUTION

 Do not exceed the maximum wattage

rating for the generator when using

one or more receptacles.

 Do not exceed the amperage rating of

any one receptacle.

 Do not apply heavy electrical load for

the first 2– 3 hours of operation

(break-in period).

Total Wattage Determination

To insure the generator is not overloaded and dam-

aged as a result, it is essential to know the total

watts of the connected load. The following steps

will help determine the intended load.

1. Determine what item or items you intend to

connect to the generator.

2. Check the wattage requirements for each item,

referring to the item’s nameplate. If watts are

not referenced on the nameplate they can be

calculated by multiplying amps and voltage

(amps x voltage = watts).

3. Add the wattage requirements for each item to

get the total wattage required.

4. Appliances and tools with motors will require

additional wattage at start up, usually 2 1/2 to 4

times their running wattage.

5. The generators rated running watts should

meet or exceed the watts required for the

equipment you intend to run.

6. Always connect the heavies load to the genera-

tor first, then add additional items one at a time

in order of descending wattage requirements.

For more information on calculating wattage re-

quirements see the panel on the top of the carton

this unit was shipped in or the charts in the back of

this manual.

CAUTION

 Check the voltage and frequency require-

ments of all electronic equipment prior to

hooking it up to a generator.

 Equipment could be damaged if it is not de-

signed to operate within +/- 10% voltage

variation and +/- 3 hz frequency variation

from the generator nameplate rating.

 To help prevent damage, always have addi-

tional load plugged into the generator if sol-

id state equipment is used.

 A power line conditioner is recommended

for some solid state appliances.

A power line conditioner is recommended when

running the following solid state items.

 Television

 Appliances with digital displays

 Telephone equipment

 Garage door openers

 Stereos

 Personal computers

 Copy machines

 Printers

 Fax machines

WARNING

Special isolation equipment is required for tem-

porary or permanent connections to a residen-

tial electrical system. Therefore, to avoid elec-

trocution or property damage, ONLY a trained

electrician should connect a generator to a resi-

dential electrical system.

Shutting Off the Generator

1. Disconnect the entire load.

2. Allow engine to run for 2-3 minutes without

load.

3. Flip ON/OFF switch to the “OFF” position.

4. Make sure the generator has completely

stopped.

5. Close the fuel shut off valve if the generator is

to be stored or transported.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hot-max-torches HM6500 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Hot-max-torches HM6500